• 877-412-3667 9AM - 3PM CST

  • ORDERS OVER $200 SHIP FREE - CONTINENTAL US ONLY

Navigate to the undefined homepage

USA Company
‚ÄčLocated in Texas

Home > Storefront Door Parts > Storefront Door Weatherstripping > Storefront Aluminum Door Pile Weatherstripping > 17/64 in. (.27") Backing Width x 1/4 in. (.25") Pile Height Storefront Door Weatherstripping

17/64 in. (.27") Backing Width x 1/4 in. (.25") Pile Height Storefront Door Weatherstripping

17/64 in. (.27") Backing Width x 1/4 in. (.25") Pile Height Storefront Door Weatherstripping

Weatherstripping is an essential component of storefront doors that prevents drafts, water, and other weather elements from entering the building. Over time, weatherstripping can wear out and become less effective, which may result in increased energy costs and reduced comfort levels. The good news is that replacing weatherstripping is a simple and affordable solution to this problem.

At Automatic Door and Hardware, we offer the 17/64 in. (.27") Backing Width x 1/4 in. (.25") Pile Height Storefront Door Weatherstripping, which is a high-quality weatherstripping that is easy to install and provides an effective seal against the weather elements.

How to Cut Out Pile Weatherstripping to Remove and Replace It

Removing and replacing pile weatherstripping is a straightforward process that can be done with basic tools and equipment. Here are the steps:

  1. First, remove any screws or nails that are holding the weatherstripping in place. Use pliers or a screwdriver to do this.
  2. Next, use a utility knife or scissors to cut through the pile fibers along the length of the weatherstripping. Be careful not to cut the backing material or damage the door frame.
  3. Once you have cut through the pile fibers, use a pair of pliers or your fingers to pull the weatherstripping out of the door frame.
  4. After removing the old weatherstripping, clean the door frame with a damp cloth to remove any dirt or debris.
  5. Measure the length of the door frame where the weatherstripping will be installed and cut the new weatherstripping to the correct length using scissors or a utility knife.
  6. Slide the new weatherstripping into the groove on the door frame, starting at one end and working your way to the other end.
  7. Once the weatherstripping is in place, use a rubber mallet or a block of wood and a hammer to tap it into place and ensure a tight fit.
  8. Finally, test the door to make sure it closes properly and creates a tight seal.

Replacing weatherstripping is an easy and cost-effective way to keep your storefront doors weatherproof and energy-efficient. At Automatic Door and Hardware, we offer a wide range of replacement parts and accessories for storefront doors, including weatherstripping, door closers, hinges, and more. Contact us today to learn more.

Filters

Filters

Sort By:
Products per page

Get The Parts That Fit

Filter your results by entering your commercial door's Make and/or Model to ensure you find the parts that fit your door.

Need A Quotation?

Receive A Free Quotation Immediately

Email custsvc@autodoorandhardware.com or call 877-412-3667 with the product you are interested in, the quantity, and any other requirements you may have. One of our specialists will email you back a free quotation shortly. Did you know we offer free design help? If you are unsure of the product you need, but know the scope of what function or application you need, our design team can help! Contact us with your inquiry today.